Before First Use - Zanussi ZDT12002FA Notice D'utilisation

• The programme indicator (A) comes on
with a fixed light.
• The programme indicator (B) starts to
flash.
5. Wait until the programme indicator (A) goes
off and the end indicator comes on (the
programme indicator (B) continues to flash).
• The acoustic signals are on.
6. Press the programme button. The end indi-
cator goes off.
• The acoustic signals are off.
7. Deactivate the appliance to confirm the set-
ting.
Activating the acoustic signals
1. Refer to 'Deactivating the acoustic signals',
step (1) through (4).
2. Wait until the programme indicator (A) goes
off. The end indicator is off and programme
indicator (B) continues to flash.

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
Adjusting the water softener
Hard water contains a high quantity of minerals
that can cause damage to the appliance and
German
degrees
(°dH)
51 - 70
www.zanussi.com
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
• The acoustic signals are off.
3. Press the programme button. The end indi-
cator comes on.
• The acoustic signals are on.
4. Deactivate the appliance to confirm the set-
ting.
Half-load
Activate or deactivate the function before
the start of a programme. You cannot acti-
vate or deactivate this function while a pro-
gramme operates.
Set this function when you want to wash a
small quantity of tableware and cookware. The
function decreases the programme duration
and the consumption of energy and water.
Load the upper basket and the lower basket
and decrease the quantity of detergent.
bad washing results. The water softener neu-
tralises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. Refer to the table
to adjust the water softener to the right level. It
makes sure that the water softener uses the
correct quantity of dishwasher salt and water.
You must adjust the water softener man-
ually and electronically.
Clarke
degrees
64 - 88
Water softener
adjustment
Manual Elec-
tronic
1) 10
2
19