Before First Use - Zanussi ZDI15001 Notice D'utilisation

2. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
3. Press and hold function buttons (D) and (E)
at the same time until the multitab indicator
comes on.
The function stays on until you deactivate
it. Press and hold function buttons (D) and
(E) at the same time until the multitab indicator
goes off.
If you stop to use the combi detergent
tablets, before you start to use separately

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
If you use the combi detergent tablets, ac-
tivate the multitab function. These tablets
contain detergent, rinse aid and other added
agents. Be sure that these tablets are applica-
German
degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
6
Water hardness
French mmol/l
degrees
(°fH)
91 - 125 9.1 - 12.5
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
detergent, rinse aid and dishwasher salt,
do these steps:
1. Deactivate the multitab function.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the shortest programme with a rinsing
phase, without detergent and without
dishes.
5. Adjust the water softener to the water hard-
ness in your area.
6. Adjust the released quantity of rinse aid.
ble to the water hardness in your area. Refer to
the instructions on the packaging of the prod-
ucts.
Adjusting the water softener
Hard water contains a high quantity of minerals
that can cause damage to the appliance and
bad washing results. The water softener neu-
tralises these minerals.
The dishwasher salt keeps the water softener
clean and in good conditions. Refer to the table
to adjust the water softener to the right level. It
makes sure that the water softener uses the
correct quantity of dishwasher salt and water.
You must adjust the water softener man-
ually and electronically.
Clarke
degrees
64 - 88
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
Water softener
adjustment
Manual Elec-
tronic
1)
10
2
1) 9
2
1) 8
2
1) 7
2
1) 6
2
1) 1)
2 5
www.zanussi.com