Zanussi ZDI 16011 Notice D'utilisation page 25

Problem
The appliance does not drain
the water.
After the checks are completed, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Service.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
Whitish streaks and stains or
bluish layers on glasses and
dishes.
www.zanussi.com
Possible cause
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
The filters are not correctly assembled
and installed.
The spray arms are clogged.
The programme was not applicable for
the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all items.
The spray arms could not turn freely.
The quantity of detergent was not suffi-
cient.
There was no detergent in the detergent
dispenser.
The salt container is empty.
The set level of the water softener is in-
correct.
The cap of the salt container is loose.
The released quantity of rinse aid is too
much.
Clean the sink spigot.
Make sure that the position of the hose is
correct.
If the display shows other alarm codes, contact the Serv-
ice.
Clean the filters.
Make sure that the filters are correctly as-
sembled and installed.
Remove remaining soil with a thin pointed
object.
Make sure that the programme is applica-
ble for the type of load and soil.
Make sure that the position of the items in
the baskets is correct and that the water
can easily wash all items.
Make sure that the position of the items in
the baskets is correct and does not cause
the blockage of the spray arms.
Make sure that you add the correct quan-
tity of detergent in the dispenser before
you start a programme.
Make sure that you add detergent in the
dispenser before you start a programme.
Make sure that there is dishwasher salt in
the salt container.
Make sure that the set level of the water
softener agrees with the water hardness in
your area.
Tighten the cap.
Decrease the released quantity of rinse aid
.
Possible solution
Possible solution
25