Before First Use - Zanussi ZDT16017FA Notice D'utilisation

If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest level.
2. Make sure that the salt container and the
rinse aid dispenser are full.
3. Start the shortest programme with a rins-
ing phase, without detergent and without
dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.
Activate or deactivate the multitab option
before the start of a programme. You
cannot activate or deactivate the option while
a programme operates.
Acoustic signals
The acoustic signals operates when the appli-
ance has a malfunction. It is not possible to
deactivate this acoustic signal.
There is also an acoustic signal that operates
when the programme is completed. By default,

Before first use

1. Make sure that the set level of the water
softener agrees with the water hardness in
your area. If not, adjust the water softener.
Contact your local water authority to know
the water hardness in your area.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
www.zanussi.com
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
this acoustic signal is off, but it is possible to
activate it.
How to activate the acoustic signal for
the end of programme
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to "Setting and starting
a programme".
2. Press and hold, at the same time,
until the
start to flash.
3. Press
.
• The
and
• The indicator
• The display shows the current setting.
Acoustic signal on.
Acoustic signal off.
4. Press
to change the setting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
4. Open the water tap.
5. Processing residues can stay in the appli-
ance. Start a programme to remove them.
Do not use detergent and do not load the
baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
, and indicators
indicators go off.
continues to flash.
Water softener
adjustment
Level
10
9
8
7
and
19