Troubleshooting - Zanussi ZDI 16011 Notice D'utilisation

D
A
5
Put filter (A) to its initial
position. Make sure that it
assembles correctly under
the two guides (D).

Troubleshooting

The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
With some problems, the display shows an alarm code:
•
- The appliance does not fill with water.
Problem
The programme does not
start.
The appliance does not fill
with water.
24
6
Assemble filters (B) and
(C). Put them into position
in filter (A). Turn the han-
dle clockwise until it
locks.
Possible cause
The mains plug is not connected in the
mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is lime-
scale on it.
The filter in the water inlet hose is clog-
ged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove remain-
ing parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
•
- The appliance does not drain the water.
•
- The anti-flood device is on.
Warning! Deactivate the appliance before you make
the checks.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Cancel the delay start or wait for the end
of the countdown.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the hose is
correct.
Close the water tap and contact the Serv-
ice.
Possible solution
www.zanussi.com