Troubleshooting; Troubleshooting Guide - Animo M100 Mode D'emploi

6.

Troubleshooting

WARNING
• Have all repairs to the electrical system performed
by a qualified service technician.
If your appliance is not functioning correctly, use the troubleshooting guide below to see
whether you can resolve the problem yourself. If not, please contact your dealer.
Symptom:
The appliance is not working
and the lamps in the switch
are not lighting up.
The brewing process indicator
light is flickering, no water is
getting into the filter.
The brewing process indicator
light is on, but no water is get-
ting into the filter.
The descale and brewing
process indicator light are
flickering in alternation.
The descale indicator light has
come on.
The descale indicator light
remains on after descaling the
appliance.
Animo

Troubleshooting guide

Possible cause:
The fuse in the fuse box has
been triggered, the group is
loaded too heavily.
The jug indicator is not regis-
tering a jug. There is no jug
under the filter, the wrong cof-
fee jug is being used or the
height adjustment of the
MT100V model is incorrect.
The dry-boil protection has
been triggered.
The appliance has heated up
for more than 20 minutes and
completely shut down.
The scaling deposits in the
heating system exceed the set
limit.
The appliance has not yet been
reset.
34
Action:
Replace the fuse or reset it.
Connect the appliance to a
separate group.
Position a jug, use the correct
jug or readjust the height of
the appliance. See chapter
3.2.5 Adjusting the height .....
Reset the dry-boil protection.
See page 23. Safeguards;
dry-boil protection.
Switch off the appliance and
then turn it back on again.
The error message will disappear.
Descale the appliance, see
chapter 5.2 Descaling.
Press the programme button
for 6 seconds. The light will go
out. See chapter 3.2.7
Resetting the descaling indica-
tor light.