Adjusting The Height Of Model Mt100V - Animo M100 Mode D'emploi

6. Switch on the appliance by setting the on/off switch (1) to the I positio. The indicator
lights (5.1 and 5.2) will light up and an audible signal will sound.
The green indicator light (5.2) will now light up until the appliance has finished
making the coffee.
7. When the appliance has finished making the coffee, a signal will sound three times
after about 1.5 minutes and the green indicator light (5.2) will go out.
8. Follow the above steps again for the other coffee making section if the model has a
double coffee making system (M102).
9. The appliance is ready for use when the jug has been emptied.
3.2.5 Height setting model MT100v
The MT100v model is in height adjustable. Follow the steps below to optimally set the appli-
ance to the height of the thermos flask being used.
1. Slide the basket filter (1) into the appliance.
2. Grasp the top part of the appliance and turn
the adjustment button (2) a half-turn anti
clockwise.
3. Lift the top part of the appliance upwards.
4. Place the thermos jug you intend to use at
the base of the appliance.
5. Now slowly allow the top section to go down
until the marking line (3) on the column is
level with the top side of the thermos jug.
(This column height adjustment must be
done with the top open if the appliance is
used in combination with a thermos jug
with a pump).
6. Tighten the adjustment button (clockwise).
7. After repositioning, check if the thermos
jug properly presses in the jug detector
handle (4) (the green indicator light (5.2)
must not blink when a coffee making process
begins).
Animo
4
28
5.2
Animo
1
3
2