Setting The Descale Indicator; Resetting The Descale Indicator Light - Animo M100 Mode D'emploi

3.2.6 Setting the descale indicator

Scale deposits are left in the heating system when the appliance is used. The amount of scal-
ing depends on the hardness of the water being used. The appliance is fitted with a descale
indicator light (5.1), which lights up when the heating system has processed a certain quantity
of water and has to be descaled. The appliance continues to work so that it can be descaled
when it is not being used.
Position Indicator lights
Soft
Normal*
Hard
*Standard setting
If you are unaware of the hardness of your tap-water, you are advised to contact your local
water supply company.
Set the appliance to your water hardness as follows, using the table above as a guideline.
1. Switch off the appliance (1)
2. Hold in the programme button (5.3) and switch the appliance back on.
3. Press the programme button (5.3) until the right indicator light (5.1/5.2) lights up.
(E.g. only the red lamp should light up for hard water).
4. Wait for 6 seconds. The water hardness has now been set.

3.2.7 Resetting the descale indicator light

After the descaling procedure (see chapter 5.2.1) hold in the programme button for 6
seconds. The descaling indicator light will now go out.
Animo
Brewing processes
512
256
128
29
Hardness
°D mmol/l
< 8 < 1,44 < 14
8 – 12 1,44 –2,16 14-21
> 12 > 2,16 > 21
°f