Black & Decker KG115 Manuel D'instructions page 9

Labels on tool
The following pictograms are shown on the
tool:
Warning! To reduce the risk of
injury, the user must read the
instruction manual.
Wear safety glasses or goggles
when operating this tool.
Wear ear protection when operating
this tool.
Electrical safety
This tool is double insulated;
therefore no earth wire is required.
Always check that the power supply
corresponds to the voltage on the
rating plate.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the
following features.
1. On/o switch
2. Side handle
3. Spindle lock
4. Guard
Assembly
Warning! Before assembly, make sure that
the tool is switched o and unplugged.
Fitting and removing the guard (Fi
g. A & B)
Fitting
• Place the tool on a table, with the spindle
(5) facing up.
• Release the clamping lock (7) and hold
the guard (4) over the tool as shown.
• Align the lugs (8) with the notches (9).
• Press the guard down and rotate it
All manuals and user guides at all-guides.com
(Original instructions)
counterclockwise to the required position.
• Fasten the clamping lock (7) to secure
the guard to the tool.
• If required, tighten the screw (6) to
increase the clamping force.
Removing
• Release the clamping lock (7).
• Rotate the guard clockwise to align the
lugs (8) with the notches (9).
• Remove the guard from the tool.
Warning! Never use the tool without the
guard.
Fitting the side handle
• Screw the side handle (2) into one of the
mounting holes in the tool.
Warning! Always use the side handle.
Fitting and removing grinding or
cutting discs (fi g. B - D)
Always use the correct type of disc for your
application. Always use discs with the
correct diameter and bore size (see
technical data).
Fitting
• Place the tool on a table, with the spindle
(5) facing up.
• Place the spring washer (6) over the
spindle and locate it on the shoulder (7).
• Place the guard (4) onto the tool as
shown.
• Place the flange (8) over the spindle with
the protruding pips towards the guard.
Make sure that the holes in the flange
align with the screw holes.
• Secure the flange with the screws (9).
Make sure that the screws are fully tight
and that the guard can be rotated.
Removing
• Use a screwdriver to remove the screws
(9).
ENGLISH
9