Black & Decker KG115 Manuel D'instructions page 13

Environmental safety
• Paint should be removed in such a
manner as to minimize the amount of
dust generated.
• Areas where paint removal is occurring
should be sealed with plastic sheeting of
4 mils thickness.
• Sanding should be done in a manner to
reduce tracking of paint dust outside the
work area.
Cleaning and disposal
• All surfaces in the work area should be
vacuumed and thoroughly cleaned daily
for the duration of the sanding project.
Vacuum filter bags should be changed
frequently.
• Plastic drop cloths should be gatheredup
and disposed of along with any dust
chips or other removal debris. They
should be placed in sealed refuse
receptacles and disposed of through
regular trash pick-up procedures. During
clean up, children and pregnant women
should be kept away from the immediate
work area.
• All toys, washable furniture and utensils
used by children should be washed
thoroughly before being used again.
Using cutting wheels
Do not use edge grinding/cutting wheels for
surface grinding applications because these
wheels are not designed for side pressures
encountered with surface grinding. Wheel
breakage and injury may result.
• Allow tool to reach full speed before
touching tool to work surface.
• Apply minimum pressure to work
surface, allowing tool to operate at high
speed. Cutting rate is greatest when the
tool operates at high speed.
• Once a cut is begun and a notch is
established in the workpiece, do not
change the angle of the cut. Changing
the angle will cause the wheel to bend
and may cause wheel breakage.
All manuals and user guides at all-guides.com
(Original instructions)
• Remove the tool from work surface
before turning tool o . Allow the tool to
stop rotating before setting it down.
Maintenance
Your BLACK+DECKER corded/cordless
appliance/tool has been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance on corded/cordless power
tools:
• Switch off and unplug the appliance/tool.
• Or switch off and remove the battery
from the appliance/ tool if the
appliance/tool has a separate battery
pack.
• Or run the battery down completely if it is
integral and then switch o .
• Unplug the charger before cleaning it.
Your charger does not require any
maintenance apart from regular cleaning.
• Regularly clean the ventilation slots in
your appliance/tool/ charger using a soft
brush or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior (when
fitted).
ENGLISH
13