Télécharger Imprimer la page

Dometic Oceanair Skysol Powered Roofblind Instructions De Montage Et De Service page 21

Publicité

Skysol Powered Roofblind
7. Re-assemble the couplings on the shaft (fig. 8, page 6).
7.2
Frame fitting
A
NOTICE! Damage hazard
• Use packing material where required (fig. 9, page 7).
• Use suitable screws and plugs for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.The heads of screws may be no
larger than 6.0 mm in diameter.
• Ensure not to drill through the wall.
• Ensure not to damage the channel in the side tracks.
• Take care not to leave screws or other debris inside the side tracks as this
can jam the shoes in the tracks.
Proceed as shown:
1. Align the blind with the window cut-out and mark where the holes are to be
drilled for the frame.
2. Ensure the frame is square within the recess by using a measuring device.
Measure the outside corner of the frame to the opposite outside corner and
repeat for the other two corners. These measurement should be within
3 mm of each other (fig. 9, page 7).
3. Fix the frame with the screws to the ceiling (fig. 0, page 7).
If packing of tracks is required do not fully tighten the screws before packers
are in place as this can cause damage to the tracks.
It might be easier to loosely fit the four corner screws (1.) first to position and
hold the blind while the main fixings (2.) are fitted.
For curved frames: Position the blind vertically using the side track screws
rather than the corner screws.
7.3
Fitting the moving rail and the blind panel
Before fitting the fabric panel observe the following:
• Ensure that the cording on each panel is routed correctly (fig. a, page 8).
Always extend the fabric panels completely before clipping them in.
• Check whether the moving rail is square and moves freely before fitting any
of the other panels. If the moving rail is not square it can be adjusted as shown
(fig. 8, page 6).
• Ensure that the gliders are inserted into moving rail correctly and are free to
move (fig. b, page 8).
For fitting the blind panels proceed as follows:
1. Fit the moving rail (fig. c, page 9). Dependent on the version the blind is
equipped with one or two moving rails.
EN
Installation
21

Publicité

loading