Publicité
Installation
2. Connect the power (see chapter "Electrical installation" on page 22) and
drive the moving rail away from the head rail before fitting the panels. There
is not enough space to fit the panels with the shoes in the shipped position.
3. Clip the fabric panel to the shoes in the side tracks (fig. c, page 9).
4. Connect the first blind panel to the moving rail (fig. d, page 10).
– Ensure that the cording is correct in the channel before clipping the extru-
sions together (fig. a, page 8).
– Insert the bottom of the cover half way into the moving rail.
– Insert the top of the cover half way into the connect rail.
– Push to fully clip in the bottom along the full length.
– Push to fully clip in the top along the full length.
5. Clip the next fabric panel to the shoes in the side tracks.
6. Extend the fabric panel to ensure the cords do not drop.
7. Clip the second fabric panel to the first fabric panel.
8. Repeat the process for all panels.
9. Power the blind to move all fabric panels towards the head rail (see chapter
"Electrical installation" on page 22).
10. Clip the last panel to the head rail (fig. e, page 11).
Ensure it is fully clipped in and flush along the full length.
7.4
Fitting the cover (optional)
➤ Proceed as shown to fit the covers (fig. f, page 12).
7.5
Electrical installation
The electrical power supply must be connected by a qualified electrician who
has demonstrated skill and knowledge related to the construction and opera-
tion of electrical equipment and installations and has received safety training to
identify and avoid the hazards involved.
The powered blinds are available for a connection to a 12/24 Vg power supply.
The data plate on the head rail provides important information on the specifica-
tions of the motor specific to the blind.
The following notes must be observed when connecting the blinds:
• Ensure cables are not damaged during installation. Routings of cables
through walls or bulkheads must be protected and insulated by appropriate
bushing, grommets or cable conduits.
• Ensure that a 12 V or 24 V stabilized power supply line is available for the
drive at the point of installation. The power supply line is suitably arranged
and protected.
22
Skysol Powered Roofblind
EN
Publicité
