Publicité
Installation
Available blind types are (see dimension drawings fig. k, page 14 to fig. m,
page 15):
• D2: Double-ended with two fabrics, full travel
• S1: Single ended with one fabric, full travel
• SO: Single-ended, frame open at one end with one fabric, full travel
The number on the product label in the head rail indicates the blind type.
I
NOTE
The motors have a built-in, self resetting thermal cut-out for safety reasons.
Prolonged use or over loading the blind could trigger the cut-out. If this
happens allow the motor to cool up to half an hour.
7
Installation
!
WARNING! Risk of injury
• Disconnect the power supply before you begin and ensure that it can not
be reconnected until installation has been completed.
• Assemble and fit the frame the with two people if the blind is large or the
mounting location is difficult to reach alone.
!
CAUTION! Risk of injury
Important safety instructions. Follow all instructions since incorrect installation
can lead to severe injury.
7.1
Frame assembly (only flat pack version)
A
NOTICE! Damage hazard
• When unpacking, leave the blue tape on the side tracks to aid assembly.
• The end of belt must be kept packaged until it is assembled to the moving
rail to prevent crushing.
• Ensure that the frame is not twisted during installation, as distortion will
damage the blind and affect the operation of the blind.
Proceed as follows:
1. Slide grommet away from coupling and loosen the coupling from the shaft
of the head rail (fig. 2, page 3).
2. Unscrew locking ring on two part spline coupling (fig. 2, page 3).
3. Slide male part away from female part to disengage shaft (fig. 2, page 3).
4. Push belt through housing sprocket (fig. 3, page 4 and fig. 5, page 5).
5. Assemble the head rail to the side track noting the correct belt channels to
use (fig. 3, page 4 to fig. 6, page 5).
6. Ensure the gliders are at the same distance from the frame (fig. 7, page 6).
20
Skysol Powered Roofblind
EN
Publicité
