Publicité
Skysol Powered Roofblind
• The product must be connected to the correct power supply as specified on
the product label. The motor in the product is designed to cut out when a set
current is exceeded but the supply should be fused to protect the wiring to
the product.
• Secure all cables to prevent any contact with moving parts.
• Only use power supply units and control elements recommended by the
manufacturer to prevent damage or faults during operation caused by incom-
patible electrical components.
• Control devices (e.g. switches) must be installed in visible locations.
• One regulated power supply of the required specification is required per
motor as failure to do so may cause the motor to function improperly.
• Any adjustment of set stop positions should only be made using the method
specified for the motor type to avoid damage to the motor.
➤ Connect the motor as shown in the wiring diagrams:
– Dometic radio controlled blind internal receiver (fig. g, page 13)
– Dometic radio controlled blind external receiver (fig. h, page 13)
– Manually switched blind (fig. i, page 13)
– Somfy radio controlled blind external receiver (fig. j, page 14)
– Somfy radio controlled blind internal receiver (fig. k, page 14)
Key to wiring diagrams
Pos.
1
2
3
4
5
bk
rd
gy
wh
I
NOTE
• Accessories are available using the separate order form.
• Observe the applicable documents for the controls and the operating ele-
ments.
EN
Description
Power supply
Head rail
Head rail motor options
External receiver
Customer supplied DPDTswitch (double pole, double throw), center off,
latching or momentary, 12/24 Vg, 3 A)
Black
Red
Gray
White
Installation
23
Publicité
