Stihl MSA 300.0 Notice D'emploi page 40

English
Condition LEDs on
Battery
Battery is not 1 LED glows
being charged red.
even though LED
on charger glows
green.
"CHAIN OIL"
LED glows red.
"CHAIN OIL"
LED flashes red.
25 Specifications
25.1 STIHL MSA 300.0, MSA 300.0
C
– Approved battery types:
– STIHL AP 300 S and AP 500 S
When using the AP 300 S, only the ECO power
level is available.
– Weight without battery, guide bar and saw
chain: 9.90 lbs. (4.5 kg)
– Maximum oil tank volume: 10.5 oz. (0.31 l)
For technical information regarding STIHL AP
series batteries, see the product information
accompanying your battery.
For technical information regarding the
STIHL AL 101, 301, 301-4 and 500 series charg‐
ers, see the product information accompanying
your charger.
Batteries, chargers and other accessories sold
are separately. Contact your authorized STIHL
servicing dealer for pricing and availability.
40
Possible Cause Remedy
Working techni‐ ► Obtain instruction on proper working technique.
que is improper
or the saw is
being mis-used.
Insufficient bar ► Increase oil feed rate,
and chain oil.
Battery too hot / ► Allow the battery to warm up or cool down grad‐
too cold. ually at ambient temperatures of about 50 °F to
68 °F (10 °C to 20 °C).
► Read and follow the warnings and instructions in
your charger's manual. For optimum perform‐
ance, observe the recommended ambient tem‐
perature ranges,
Insufficient bar ► Filling the Chain Oil Tank,
and chain oil in
► Adjust the oil pump to the maximum flow rate of
the tank, or the
bar and chain oil.
bar and chain
► Select the maximum power level,
are not receiving
► Switching on the chain saw and run the chain
oil.
saw for approximate 1 minute.
„CHAIN OIL" LED goes out. The oil pump can
be set for operate the chain saw.
The bar and ► Filling and using new bar and chain lubricant,
chain lubricant is
dirty, old, too
► If the LEDs still glows, have the chain saw
dark to be detec‐ checked by an authorized STIHL servicing
ted by the oil
dealer.
sensor, or other‐
wise unsuitable.
The chain oil ► Have the chain oil sensor checked by an author‐
sensor is dam‐ ized STIHL servicing dealer.
aged.
25.2
The following chain sprockets are available for
this model chain saw:
– 8-tooth for .325" pitch
25.3
The minimum groove depth of a guide bar
depends on the pitch of the guide bar.
– Minimum groove depth for .325" pitch guide
25.4
The depth gauge setting of a saw chain depends
on the pitch of the chain.
– Depth gauge setting for .325" pitch chains:
25.6.
13.4.1.
Chain Sprockets
– Maximum chain speed: 30.0 m/s
Minimum Groove Depth of
Guide Bars
bars: 0.236 in. (6 mm)
Depth Gauge Setting
0.026 in. (0.65 mm)
25 Specifications
13.4.3.
13.4.2.
18.1.
0458-009-8202-B