Device Functions; Before Fi Rst Use - Cleanmaxx TSK-7988UP86A Mode D'emploi

EN

Device functions

• The device has an electronic temperature control for reliably setting the selected
temperature and maintaining it when the iron is connected to the mains supply.
• In the event of overheating, the device will switch off.
• The anti-drip system switches off steam production to prevent water from dripping
out of the soleplate at a low temperature. NOTICE: The anti-drip system may emit a
clicking noise while heating up or cooling off. This is normal and does not represent
a defect.
• The ceramic coating of the soleplate allows the device to effortlessly glide over the
fabric when ironing.
• The water scale fi lter of the device removes water scale from the water in the water
tank. However, keep in mind that it cannot absolutely prevent the formation of water
scale.
• The device has automatic safety switchoff function: It will stay on for approximately
30 minutes and then automatically deactivate if you don't move it. When the device
turns off, you will hear a signal.
CAUTION: It takes a little while for the bottom of the iron to cool down. Even
once the device deactivated, never leave it unattended while it is still connected
to the mains power!
Before fi rst use
ATTENTION!
• The plastic foils and bags pose a suffocation hazard! Keep children and animals
away from the packaging material.
• Any water residue in the water tank is attributed to previous testing of this device and
does not constitute a fault.
• Unpack the product contents and make sure that they are complete (see chapter
"Product contents and device overview") and check for any damages from transport.
If the device, the adapter, plug or mains cord exhibit damages, do not use the device
(!); instead contact customer service.
• Before you use the device, remove all packaging material and any labels located on
the device and which serve to provide protection during transport or are for advertis-
ing purposes.
• Before using the device to iron an article of clothing for the fi rst time, iron a damp
piece of fabric to remove any production residue from the soleplate (see chapter
"Use").
• Be sure to read through the chapter "Ironing recommendations" before fi rst use!
22