Gaggia Milano La Dea Mode D'emploi page 33

Les langues disponibles

MANUAL DE INSTRUCCIONES

Electrical

· We consider that the machine has been installed correctly when this has

Connection

· The machine must be installed in accordance with the local electrical regula-

· No extension leads or multiple sockets of any kind should be used to con-

HandlingÊ

Nota: The sound pressure of this appliance does not exceed 70 dB.

Check that all electrical connection characteristics coincide in voltage, fre-

quency and power to those described on the machine's rating plate. The

rating plate is located on the chassis under the drainage tray.

been done by means of a magneto-thermal omnipolar circuit breaker suita-

ble for the power of the machine, together with a differential that does not

exceed a residual current of 30 mA.

tions in force. It must be ensured that the electrical installation is reliably

earthed in accordance with the above-mentioned standards. The company

accepts no responsibility for any possible damage caused by faulty installa-

tion or earthing.

nect the machine to the mains supply. The mains connection cable should

never be coiled up, but should be extended as far as possible to avoid over-

heating.

· Any internal handling of the machine, except where specifically descri-

bed in this manual concerning cleaning procedures, must be carried out

by an authorised service technician.

· Cleaning and preventive maintenance must be carried out as frequently

as indicated by the machine or the service centre.

· The manufacturer accepts no responsibility for any possible damage to

the machine caused by failure to comply with these obligations, or for

any damage due to incorrect or inappropriate use of the machine.

· All components of the machine, including the connection cable, shall be

replaced only with original spare parts that can be supplied by the autho-

rised service centre or the manufacturer.

· Before proceeding with any maintenance operation, the machine must

be disconnected from the power supply either through the general switch

of the installation or by disconnecting the power cable.