Publicité
Installing your child restraint in the vehicle - Forward Facing mode
5. Push the child restraint firmly into
the vehicle seat and pull the vehicle belt
eliminating any slack. While pushing the
seat down (A), pull the lap portion of the belt
from the fixed point toward the buckle (B).
Then pull the diagonal portion of the belt (C).
6. Close the lockoff
procedure shown in picture (D and E).
Make sure that only the lap portion of the
belt passes through the opened lockoff clip
on the side where the shoulder strap goes up
to the retractor (picture 6).
7. Open the lockoff clip on the buckle side.
Make sure that both the lap and shoulder
belts go through the lockoff near the buckle.
Close the lockoff clip following the procedure
shown in picture 6 (D and E).
Attach the TOP TETHER strap to your vehicle
following instructions at page 24.
Picture shows the correct belt pattern
when
the
child
in the forward facing mode using a
lap and shoulder belt and top tether.
Verify that the child restraint is secure. A
secure child restraint will not move more than
2.5 cm (1 inch) near the seat belt anchor.
Important Note: The lock off clips located
All manuals and user guides at all-guides.com
clip following the
restraint
is
installed
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate.
A
C
B
- 42 -
5
E
D
7
6
Publicité
