Publicité
Installing your child restraint in the vehicle
2.1 Lap/shoulder belt (3-point) with
Switchable Locking Retractor (ELR —>
ALR) and free sliding latch plate. This
type of seat belt has a latch plate that moves
freely along the belt. To activate ALR for child
restraint installation, some vehicle models may
require to pull the belt all the way out; some
other vehicle models may require to pull the
belt for a certain length (check vehicle owner's
manual for details).
For installation of Primo Viaggio SIP Convertible
in rear facing mode, leave the seatbelt in ELR
mode and use a locking clip available with
your child seat (in rear compartment). Use
of a locking clip is explained at page 34. For
installation of Primo Viaggio SIP Convertible
in forward facing mode, activate ALR mode,
then tighten the belt around the seat feeding
the belt back into the retractor. The belt will not
extend unless you unbuckle the belt and repeat
the operation from the beginning. With this
installation, use of a locking clip is not required.
All manuals and user guides at all-guides.com
Important Note: The lock off clips located
on the side of the Convertible seat are used to
enhance the stability during normal use. The lock
offs are not designed to replace an automatic
locking retractor or a locking latch plate. The
vehicle belt must be properly tightened to secure
the Convertible seat to the vehicle.
- 18 -
ELR
ALR
FF
RF
√
Publicité
