Publicité
Installing your child restraint in the vehicle - Forward Facing mode
Important! Remove newborn filler cushion in
forward facing mode (see page 53).
Important! Do not use rebound bar in forward
facing mode.
FORWARD
FACING
LAP BELT (TYPE I)
1. Before installing the child restraint in the
vehicle, make sure that the backrest is in the
upright position or adjust it using the handle
located below the front edge of the shell (A)
as shown in detail.
2.
Lean
the
upright
unoccupied, on the selected vehicle seat.
Make sure that the UAS straps are stored in
their proper location (page 38 - picture2) and
that the rear openings in the structure are
free and ready for use. Open the lock-off clips,
as shown in the picture .
3. Pull the vehicle belt at full available length
and thread the belt through the openings
in the structure behind the child restraint as
shown in the picture.
4. Buckle the vehicle belt and check that the
vehicle belt is free of any entanglement.
All manuals and user guides at all-guides.com
MODE
USING
child
restraint,
- 43 -
1
A
B
A
3
2
4
Publicité
