Yamaha HTY-7040 Mode D'emploi page 41

Masquer les pouces Voir aussi pour HTY-7040:

Les langues disponibles

Assembling the supplied cardboard

microphone stand

You will find three separate parts (one circular part and

two longitudinal parts) of the cardboard microphone stand

originally put together.

Disassemble the three parts of the cardboard

microphone stand originally put together.

Insert one of the longitudinal part into the

crevice of the other longitudinal part.

Place the circular part on top of the two

combined longitudinal parts.

Place the supplied IntelliBeam microphone

on top of the circular part.

Using AUTO SETUP (IntelliBeam)

Once the IntelliBeam microphone is firmly connected to

this unit and properly placed in your listening room,

follow the procedure below to start the AUTO SETUP

You can also enter the AUTO SETUP procedure simply by

pressing and holding AUTO SETUP for more than two

seconds. In this case, this unit performs both of the beam

optimization and sound optimization procedures.

(U.S.A. and Canada models)

AUTO SETUP (IntelliBeam)