Yamaha HTY-7040 Mode D'emploi page 23

Before connecting components
Cables used for connections
Audio/Video
A
HDMI cable
Audio
Audio pin cable (supplied)
(White)
(Red)
Optical cable (supplied)
Digital audio pin cable (supplied)
(Orange)
3.5 mm stereo mini plug cable
5
Subwoofer pin cable
Video
OSD video pin cable (supplied) / Video pin cable
(Yellow)
Component video pin cable
(Green)
(Blue)
(Red)
Notes on connecting the optical cable
• Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put the cap
back in place.
• When inserting the cable into the optical digital jack, make sure
the direction is correct.
Cap
Affixing cables
To prevent cables from becoming unplugged, place the supplied cable
clamp with the open side facing upward, attach it to the rear panel of
this unit in a suitable position, and then affix cables in the cable clamp.
Information on HDMI™
(White)
Audio signals
Input source
(Red)
DVD video
DVD audio
Blu-ray Disc
HD DVD
(Orange)
Notes
• When CPPM copy-protected DVD audio is played back, video and
audio signals may not be output depending on the type of DVD player.
• This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
y
• We recommend that you use an HDMI cable shorter than 5 m
(16 ft) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack
this unit to other DVI components.
Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
(Yellow) order: HDMI → Digital → Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
Input
(Green)
jack
Input
(Blue)
Source
(Red)
TV/STB
DVD
AUX 1
AUX 2
AUX 3
Connections
Optical cable
Attach to this unit
Audio signal type
Dolby Digital, DTS, PCM
2-channel stereo
(up to 96 kHz/24 bit)
Dolby Digital, DTS, PCM
↔
DVI-D jack) to connect
HDMI Digital Analog
21
En