Publicité
Les langues disponibles
Les langues disponibles
bringing the Power Level to
USING THE EXTRACTOR
● Switching the extraction system on:
• Switch on the hob as indicated in the "Power-on" chapter
on "using the hob";
● Extraction speed (power):
The extractor is equipped with 3 levels of extraction speed
(power).
Touch and slide your fingers along the Selection bar (3):
to the right to increase the power level, to the left to
decrease the power level.
Note: The set power level will be displayed in the
Selection/Display area (12)
● Power Booster
The extractor fan has 2 additional power levels (beyond
level 3)
Power Booster 1: timed for 15 min.
Power Booster 2: timed for 5 min.
After which the power returns to the previously set level.
Touch and slide your fingers along the Selection bar (3)
(past level 3), and activate the Power Booster 1, the level
will be shown in the Selection/Display area (12) with the
number "4" flashing.
Touch and slide your fingers along the Selection bar (3)
(past level 3), and activate the Power Booster 2, the level
will be shown in the Selection/Display area (12) with the
symbol"
"
● Automatic mode
The hood will turn on at the most suitable speed, adapting
the extraction capacity to the maximum cooking level used
in the cooking zones.
When the cooking zones are switched off, the hood adapts
its extraction speed, decreasing it gradually, to eliminate
residual vapours and odours.
To activate this function:
Press
(14);
Repeat the operation to deactivate.
Note: if, during automatic operation, the speeds from 1 to
3 are selected using the Selection bar (3), automatic
operation is interrupted; if, on the other hand, the Power
Booster is selected, automatic operation will resume at the
end of the timer and, in the meantime, the symbol
keeps flashing.
Note: if the hob automatically shuts down with Automatic
.
mode active, the extractor fan will automatically turn off
gradually.
● Filter saturation indicator
The hood indicates when filter maintenance is needed:
For the carbon/ceramic odour filters, FILTER (13) lights up
For the grease filter, FILTER (13) lights up and flashes
Note: this function is disabled by default (see how to
enable it in the paragraph "Activation of filter saturation
indicator")
● Reset filter saturation
After performing maintenance on the filters (grease and/or
carbon/ceramic) press and hold FILTER (13); it will turn off
and the indicator counter will restart.
● Activation of filter saturation indicator
Note: This indicator is normally deactivated.
To activate it, proceed as follows:
• turn the extractor hob on
• with the extraction motor and cooking zones off, press
the Selection zone (12)
• hold HOOD (11) pressed until the Display (12) shows the
letters
and
flashing alternately.
= carbon/ceramic odour filters;
CARBON/CERAMIC ODOUR FILTERS
• press the Display (12) when the letter
• press FILTER (13) fixed light.
• press and hold HOOD (11) again to confirm the
activation of the carbon/ceramic
odour filter.
GREASE FILTER
• press the Display (12) when the letter
• press FILTER (13) flashing light.
• press and hold HOOD (11) again to confirm the
activation of the grease filter indication.
28
;
= grease filters;
appears
appears
Publicité
