Publicité
Les langues disponibles
Les langues disponibles
● Cooking Zone Timer
The Cooking Zone Timer function is a countdown that can
be set, even simultaneously, on each cooking zone. At the
end of the period set, the cooking zones switch off
automatically and the user is notified with a dedicated
acoustic signal.
Activation of the cooking zone timer function
• Touch (press) the Selection/Display area (2) (power
level other than zero)
• Press
(6) relating to the cooking zone
• Use the symbols
Timer, which is shown in the Zone/Display (4); while
setting, the symbol
(6) flashes.
Note: wait 10 seconds without pressing any other
command, so that the Cooking Zone Timer will start.
Note: by pressing and holding
zone Timer is reset.
If desired, repeat the operation for several cooking
zones:
Each cooking zone can have a different Timer set; in the
display (4) the countdown of the cooking zone selected at
that moment will appear; if no zone is selected, press the
Display (4) to view the STAND-ALONE Timer countdown.
When the timer has finished the countdown, an acoustic
signal sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
The countdown display mode is the same as for the
STAND-ALONE Timer.
● Bridge Zones
Thanks to the Bridge function, the cooking zones can
operate in a combined way, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
It is possible to use the front cooking zone in combination
with the corresponding rear one (to check which zones
feature this function, see the illustrated part of this
manual).
To activate the Bridge Function:
• simultaneously select both cooking zones you wish
to use
• the Display (2) of the "rear" cooking zone will show the
symbol
• using the Selection bar (3), it will be possible to set the
operating Level (Power), which will be shown on the
Display (2) of the "front" zone
To disable the Bridge Function, simply repeat the
activation procedure
Note: the Cooking Zone Timer, activated during the Bridge
(5) to set the duration of the
(6) again, the cooking
, using
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single
combined area.
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the ON/OFF (1) button, when the hob is
connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press
(which will flash, only for the first 2 minutes
after the product has been switched on)
• while continuing to hold down
time, all the Selection/Display areas (2) of the cooking
zones in a counter-clockwise direction starting from the
front left zone (FR); a short acoustic signal will be emitted
with each press and when all the Displays (2) have been
pressed, it will be possible to release the key:
(5).
at this point, the Display (2) of the rear left zone (RL) will
show, in alternating sequence, the symbols
indicating that the setting can be made.
• select the Display (RL-2) then slide along the Selection
bar (3), until the Display shows the symbols
The Display (FL-2) will show the current setting with the
values in the table:
Displayed value
To change the Power Limitation setting:
• press the Display (FL-2) then slide along the Selection
bar (3), to
set the new setting. To save the selection made, press the
26
, press, one at a
and
and
Power (Kw)
7.4 Kw (default setting)
4.5 Kw
3.1 Kw
,
;
Publicité
