Amana CARDS801 Serie Mode D'emploi page 8

31/4 x 10 Wall Cap without Flap
1
CC30 Wall Cap with Flap = 7
(available from dealer)
All manuals and user guides at all-guides.com
/ Ft.
2
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket(s). Use either
rectangular or L-shaped anti-tip bracket packed with
range. Follow appropriate instructions.
L-shaped Anti-tip Brackets
1. Measure 5 1 / inches from back wall on right and left
8
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip brackets with inside edge over line
drawn on floor and end of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with inside edge over
1
line drawn 5 / inches from back wall and end of
8
bracket over line drawn along side of range on
floor.
• Anti-tip bracket must be installed on both right and
left side.
3. Mark 2 hole locations in each anti-tip bracket.
4. Drill holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. Slide range into position.
7. Remove range storage drawer and confirm anti-tip
bracket is engaged with range leveling leg.
8
3 / inch drill bit.
32
3
/ inch masonry drill
16