Publicité
Les langues disponibles
Les langues disponibles
Installation
Packing Material
Remove protective packing materials from range. Tape
residue can be cleaned with a soft cloth and alcohol.
Range Location
Choose a location based on following factors.
WARNING
To avoid risk of burns or fire by reaching over heated
surface units, cabinet storage space located above
range should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 5 inches
beyond the bottom of the cabinets.
• Range is designed to be vented outdoors.
• Drafts caused by home heating and air conditioning
and open doors or windows can disrupt ventilation
air pattern. Range should not be installed near
windows or doors.
• Range can not be installed in a tunnel type wall
opening. Air currents moving through tunnel can
disrupt ventilation air pattern.
• Range can either be ducted through wall or through
floor to outside.
• Make sure there is adequate space for proper
installation.
• Carefully read all instructions before beginning
installation.
Remove protective packing materials from range. Tape
residue can be cleaned with a soft cloth and alcohol.
Standard Cabinet and Counter top Height
All manuals and user guides at all-guides.com
5
Cabinet Opening
Range should extend approximately 1
front to oven door handle. Remove venting kit from
storage drawer. Using dimensions in figure below and
Special Counter top Conditions section to
show n i n
prepare cabinet opening.
Range Dimensions:
WIDTH - 29
15
/
inches
16
DEPTH - 29 inches (with handle)
HEIGHT - 36 inches
Minimum Clearances to Combustible
Surfaces
• Minimum clearance to rear wall is 0 inches.
• Minimum clearance to a vertical right or left side
wall is 0 inches.
• Minimum clearance to counter top/cabinet on each
side is 0 inches.
• Minimum of 30 inches between top of cooking
surface and bottom of an unprotected wood or
metal cabinet.
• 24 inches between cooking surface and protected
wood or metal cabinet above range. Cabinet bottom
must be protected by at least ¼ inch thick
millboard with not less than No. 28 MSG sheet
steel, .015 inch thick stainless steel, .024 inch
thick aluminum, or .020 inch thick copper.
E
D
A—30 inches unprotected/24 inches protected minimum
B—25 inches maximum
1
C—30
/
inches minimum
8
D—36 inches maximum
E—13 inches maximum
1
/
inch from cabinet
2
A
B
C
Publicité
