Publicité
Les langues disponibles
Les langues disponibles
Backwall Duct Connection
1. Remove screw in front of blower transition separating
blower transition from blower housing.
2. Place hose clamp around round end of blower
transition and attach flex duct to blower transition
using hose clamp.
3. Place long end of thimble into wall and secure thimble
using four screws provided, one in each corner.
4. Place hose clamp provided around short end of
thimble. Attach opposite end of flex duct to short end
of thimble using hose clamp.
5. Connect electrical supply.
6. Carefully push range back into position. Avoid
pinching transition piece or flex duct.
7. Using guide screw to locate hole in rear of blower
housing position transition inside blower housing.
Rotate transition until hole in front of blower housing
is aligned. Secure transition with screw provided.
8. Seal all duct joints with duct tape.
9. Check under range to be sure leveling leg is fully
engaged in the anti-tip bracket.
10. Install storage drawer.
Backwall Duct Connection
Flex Duct
Blower Transition
Screw
All manuals and user guides at all-guides.com
Thimble (attach to wall)
(Hose clamp)
Blower
Guide Screw
Floor Duct Connection
1. Attach rubber gasket around edge of transition piece.
• Flat side of rubber gasket must be on under side of
transition piece. See figure below.
2. Place round end of transition piece into floor. Secure
transition piece using 8 screws provided in kit.
• Lift edge of rubber gasket to install screws.
• Make sure round edge of gasket is facing up.
3. Insert floor plate into elbow duct.
• When installed, wide flange of floor plate should
face toward back of range. If gap exists in front of
cutout, rotate transition piece 180°.
4. Attach floor elbow duct to floor plate using 2 screws
provided.
• Tighten only front screw.
5. Attach floor elbow duct to blower using 2 screws
provided.
• Floor elbow duct should be inside blower.
6. Connect electrical supply.
7. Push range into position.
• Tilt range slightly while pushing in range. Tilting
range allows floor plate to clear gasket.
• Make sure that floor elbow duct is directly over
transition piece and rubber gasket.
• Rubber gasket provides a seal between floor elbow
and transition piece. See figure below.
Floor Elbow Duct
Transition Piece
Floor Plate
11
Publicité
