Amana CARDS801 Serie Mode D'emploi page 15

Cooking with Smoothtop Module
WARNING
To avoid risk of serious personal injury never cook on
a broken smoothtop module. Spillovers or cleaners
can penetrate surface of module and create a risk of
electrical shock. If smoothtop module breaks,
discontinue use and notify an authorized servicer
immediately.
CAUTION
Do not use cast iron cookware. Cast iron retains
heat and may result in cooktop damage.
• Use heavy-gauge metal cookware not including
cast iron.
• Bottom of cookware must be flat. Cookware that is
warped or slightly curved on the bottom heats
slowly and may not boil water. Cookware with an
aluminum disk bottom makes excellent contact
with cooking surface. See Utensils section for more
information.
• Do not use glass, glass-ceramic, or enamel-
porcelain cookware. Small imperfections on bottom
of such cookware can scratch smoothtop module
surface.
• Module surface is not "scratch proof". Surface is
highly scratch and impact resistant. With
recommended cooking utensils and proper care, it
will continue looking good through years of use.
• Do not use a pan that overhangs burner by more
than 1 inch.
WARNING
To avoid risk of serious personal injury, property
damage, or fire, do not leave surface elements
unattended while in operation. Grease and spillovers
can ignite causing a fire.
1. Push in and turn surface element control to desired
setting.
• Range has two indicator lights, one for each right
and left side module elements. When either front or
rear element is on, corresponding indicator light
glows red.
2. When finished cooking, turn control to "OFF".
All manuals and user guides at all-guides.com
15
Surface Element Settings
LO
Use to prepare food at less than boiling temperatures or
to simmer.
MED LO
Use to maintain boiling in moderate amounts of liquid.
MED
Use to maintain boiling of larger amounts of food, low
temperature frying and to maintain correct pressure in a
pressure cooker.
MED HI
Use to fry meat and poultry or to maintain deep-fat frying
temperatures.
HI
Use to bring food to boiling temperatures. When food is
boiling temperature setting should be reduced to MED LO
through MED HI.
Exhaust Fan
Two speed fan is built into the middle of range top. Fan is
located beneath the vent area. Fan is necessary to
remove cooking vapors, odors, and smoke.
• The fan automatically turns on at low speed when
using grill or griddle. Fan can be manually turned up
to high speed.
• Fan cannot be turned off while grill or griddle are
operating.
• Fan can be used during any cooking operation.
1. Turn fan knob to desired setting.
2. Turn fan to "OFF" when you are finished using it.
Oven Light
• Used to light inside of oven.
• Switch is located on control panel.