3M DBI SALA 2100103 Manuel D'instructions page 6

;
Prior to installation and use of this equipment, record the product identification information from the ID label in the
Inspection and Maintenance Log (Table 2) at the back of this manual.
PRODUCT DESCRIPTION:
Figure 1 illustrates the 3M™ DBI-SALA™ Toggle Anchor. The Saflok
horizontal, vertical, or overhead applications. The Toggle Anchor is designed for use in a Steel Flange, Pre-Cast Concrete Plate or Pre-
Cast Hollow Core Concrete. After insertion through a 19.05 mm (3/4 in.) or 20 mm mounting hole, the Toggle rotates perpendicular to
the mounting hole to secure the Toggle Anchor. Squeezing the Swivel Ring and Hole Plug together compresses the Spring and rotates
the Toggle for immediate removal from the mounting hole.
Figure 2 illustrates components of the Toggle Anchor. See Table 1 for Component Specifications. The Toggle Anchor is comprised
of a Swivel Ring (A) attached to a Main Cable (D), and an activator cable (E) to adjust to the depth of the installation structure.
The Main Cable is covered by a Spring (H). The Toggle Anchor has a Hole Plug (F) and is locked in place with a Toggle (G). The
Fall Arrest subsystem connects to the Swivel Ring (A) on the end of the Toggle Anchor.
System Specifications:
Capacity: 1 Person with a combined weight (clothing, tools, etc.) of no more than 141 kg (310 lbs).
Anchorage: Fall Arrest: The structure to which the Anchorage Connector is attached must sustain arresting loads
applied in the directions permitted by the Fall Arrest System of at least 6 kN (1350 lbs). Only one personal
protective system may be connected at one time.
;
For emergency rescues it may be acceptable to connect more than one system if the anchorage
will support the anticipated loads. When more than one Restraint System is attached to an anchorage,
the static load must be multiplied by the number of Restraint Systems attached to the anchorage.
Restraint: The structure to which the Anchorage Connector is attached must sustain static loads applied
in the directions permitted by the Restraint System of at least 13 kN (3,000 lbs).
Dimensions: See Figure 1 for the dimensions of each Toggle Anchor model.
Weight: 0.29 kg (0.64 lbs)
Standards Meets the test requirements of EN 795:2012 Class A
Table 1 – Specifications
Component Specifications
Figure 2 Reference Component
Swivel Ring
A
Label
B
Red Warning Tube
C
Main Cable
D
Activator Cable
E
Hole Plug
F
Toggle
G
Spring
H
Retaining Ring
I
Toggle Anchor (Figure 1) is a re-usable anchor point for
®
6