3M DBI SALA 2100103 Manuel D'instructions page 10

1 - Toggle is secure
2 - Toggle is not secure
3.4 TO REMOVE THE TOGGLE ANcHOR: Refer to Figure 2. To release the Toggle Anchor, push the Swivel Ring (A) toward
the Hole Plug (F) to compress the Spring (H) and then pull the Toggle Anchor out of the mounting hole.
4.0 USE
4.1 BEFORE EAcH USE: Verify that your work area and Personal Fall Arrest System (PFAS) meet all criteria defined in
Section 2 and a formal Rescue Plan is in place. Inspect the Toggle Anchor per the 'User' inspection points defined on the
"Inspection and Maintenance Log" (Table 2). If inspection reveals an unsafe or defective condition, do not use the system.
Remove the system from service and destroy, or contact 3M regarding replacement or repair.
4.2 FALL ARREST cONNEcTIONS: The Toggle Anchor is used with a Full Body Harness and Energy Absorbing Lanyard or
Self-Retracting Device (SRD).
5.0 INSPECTION
5.1 INSPEcTION FREQUENcY: The Toggle Anchor must be inspected at the intervals defined in Section 1. Inspection
procedures are described in the "Inspection and Maintenance Log" (Table 2). Inspect all other components of the Fall
Protection System per the frequencies and procedures defined in the manufacturer's instructions.
5.2 DEFEcTS: If inspection reveals an unsafe or defective condition, remove the Toggle Anchor from service immediately and
contact 3M regarding replacement. Do not attempt to repair the Fall Arrest System.
5.3 PRODUcT LIFE: The functional life of the Fall Arrest System is determined by work conditions and maintenance. As long
as the product passes inspection criteria, it may remain in service.
6.0 MAINTENANCE, SERVICING, STORAGE
6.1 cLEANING: Periodically clean the Toggle Anchor's metal components with a soft brush, warm water, and a mild soap
solution. Ensure parts are thoroughly rinsed with clean water.
6.2 SERVIcE: If the Toggle Anchor has been subject to fall force or inspection reveals an unsafe or defective conditions,
remove the system from service and contact 3M regarding replacement or repair.
6.3 STORAGE AND TRANSPORT: When not in use, store and transport the Toggle Anchor and associated fall protection
equipment in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical vapors may exist.
Thoroughly inspect components after extended storage.
7.0 LABELS
Figure 12 Illustrates labels on the Toggle Anchor. Labels must be replaced if they are not fully legible. Information provided on
each label is as follows:
A Read all instructions.
Front 1) Notified Body ID 2) Safety Standard 3) Manufacturer Address
Installation Material Specifications
A
Back
Red Warning Tube
A Top of activator cable
B Red Warning Tube
A Top of activator cable
B Red Warning Tube
10