Assembly - Bien-Air Dental OPTIMA INT Instructions D'installation

OPTIMA INT
The essential requirements for immunity testing is to maintain the visual luminous intensity of the LED and
the motor speed. The maximum allowed speed deviation is ±10%.
U
NOTE is the a.c. mains voltage prior to application of the test level.
T
NOTE 1 Not applicable for the board itself. Applicable when integrated in a dental unit.
NOTE 2 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 3 These guidelines may not apply in all situations. Electromagnetic propagation is affected
by absorption and reflection from structures, objects and people.
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic
site survey should be considered. If the measured field strength in the location in which the
OPTIMA INT is used exceeds the applicable RF compliance level above, the OPTIMA INT should be observed to
verify normal operation. If abnormal performance is observed, additional measures may be necessary, such as
reorienting or relocating the OPTIMA INT.

Assembly

IMPORTANT!
Before use, please read these pro-
duct instructions and the operating
instructions carefully.
Switch on only when the system is ready for
use.
Note! In order to conform to the IEC 60601-1-2
standards, take into account the different routes
of the wires through the unit (bend, fold, section
etc) and only use the transformer provided with
the kit or the unit's power supply.
In order to maintain warranty, this device must
be installed with the greatest care. Follow all
the necessary instructions.
Fixation
The unit is supplied with an angled mounting bracket REF 1302927 enabling the unit
to be fitted on the right or left side of a dental unit.
1x aluminium angled bracket
2x hole Ø 4.7 mm
REF 1302927
To fit on the left side, turn the angled mounting
bracket through 180°.
4x screw REF 1302925
9