Publicité
Les langues disponibles
Les langues disponibles
en
Chapter 8
100
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
Fault diagnosis
Display Cause
Configuration
incorrect or
modified
Supply voltage
too low
Operating Instructions
Remedying the error
Check the configuration (number of
sensors, operating modes) of the
system.
Switch the device off and on again.
After the rectification of an error
perform a complete functional test as
defined in chapter 6.3 Test notes.
Check the supply voltage and the
power supply. If necessary, replace
defective components.
Switch the device off and on again.
8010009/1HGT/2022-11-21
L4000 system
Subject to change without notice
Publicité
