Receptacle Wiring Diagram - Napoleon Plazmafire 48 Manuel D'installation Et Operation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7.3

receptacle wiring diagram

Remove the two screws that secure the junction box assembly to the wall mount plate and remove
A.
the junction box assembly. The junction box assembly must be secured to the wall mount plate (as
illustrated).
note:
If desired, the wiring from the junction box can be wired through the top and/or bottom knockouts
on the electrical housing box and run through the outlet on the outer left panel.
Route the supply wire through the 7/8" (22mm) hole of the junction box plate with a box connector
B.
(not supplied).
Connect the 120 volt supply wire to the receptacle as per the CSA C22.1 Canadian Electrical Code in
C.
Canada or the ANSI/NFPA 70-1996 National Electrical Code in the United States.
Once the wiring is complete, reinstall the junction box assembly by reversing step A making sure all
D.
wires are secure in the junction box.
electrical information
W415-1606 / D / 08.23.18
EN
29

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Whd48nWhd48p

Table des Matières