Child Proof Function; Low Battery / Manual Bypass; In The Event Of A Power Failure; Manual Operation - Napoleon Plazmafire 48 Manuel D'installation Et Operation

operation
EN
8.9

child proof function

This function will lock the keys to avoid unsupervised operation.
A. Press the MODE and UP keys at the same time.
B. To de-activate this function, press the MODE and UP keys at the same
time.
8.10

low battery / manual bypass

The life span of the remote batteries depends on various factors: quality of the
batteries, the number of ignitions, etc.
When the transmitter batteries are low, a battery icon will appear on the LCD
display before all battery power is lost. When the batteries are replaced, this icon
will disappear.
When the receiver batteries are low, no "beep" will be emitted from the receiver
when it receives an ON/OFF command. This is an alert for the receiver that there's
low battery. When the batteries are replaced, the "beep" will be emitted from the
receiver when the ON/OFF key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the
three position slider switch on the receiver to the "ON" position. This will bypass the remote control feature
and the appliance main burner will come on if the gas valve is in the "ON" position.
8.11

in the event of a power failure

If the receiver is equipped with batteries they will enable fl ame height control or ON/OFF function to control
the fi replace during a power failure. Refer to "APPLIANCE OPERATION" section when communications
between receiver and transmitter have been lost. The receiver will emit a "beep" sound to confi rm
programming has been successful once power is restored. During a power failure, if the fi replace was on, the
fl ame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on, the
fl ame height will come on at "HI". The fl ame height can then be controlled by the remote.
8.12

manual operation

The appliance can be manually overridden by the optional
remote receiver switch located either on the right side of the
appliance or hard wired into the wall. If necessary, change the
operation from 'REMOTE' by either sliding the switch up to
'ON' or down to 'OFF'.
NOTE : 'ON' and 'OFF' on the remote receiver only controls
the gas.
34
W415-1606 / D / 08.23.18
76
°F
35.10A
76
°F
35.13A
35.14A