Receptacle Wiring Diagram; Battery Back-Up Installation - Napoleon HD4N Instructions D'installation Et D'utilisation

7.2

RECEPTACLE WIRING DIAGRAM

PRONGE
CEPTACLE
ELECTRICAL BOX
(BLACK)
GROUND
(GREEN)
WIRE
NUTS
NOTE: Ensure that the transformer is plugged into the receptacle.
7.3

BATTERY BACK-UP INSTALLATION

In case of a power outage locate your battery housing (supplied in the manual baggie).
A.
Install the 4 "AA" batteries, if not already installed.
B.
Connect the battery housing to the battery connector located in the bottom corner of the appliance
C.
(refer to the illustration below).
NOTE: It is recommended that you change the battery at the start of the heating season.
(WHITE)
CONTROL BOX
L1
(BLACK)
CABLE
CONNECTOR
ELECTRICAL
GROUND
L2
COVER
(GREEN)
(WHITE)
W415-1146 / A / 02.16.13
39
EN