42
7.2
RECEPTACLE WIRING DIAGRAM
PRE-FINISHING
ACCESS PANEL
7.3
REMOTE RECEIVER INSTALLATION
Receiver must be located within 8 feet
of this side of the appliance and must be
accessible for programming the remote.
Install the receiver into a standard
electrical switch box. Determine an
appropriate location and install the
electrical box.
NOTE: Ensure the 3 position slider
switch is in the "REMOTE" position
(middle).
W415-0745 / E / 08.15.12
ELECTRICAL COVER
NOTE: RECEIVER WIRE IS BUNDLED
UP BEHIND THE ELECTRICAL COVER
AND NEEDS TO BE INSTALLED
REMOTELY. FOR INSTALLATION SEE
"REMOTE RECEIVER INSTALLATION"
SECTION.
L1
L2
CABLE CONNECTOR
PLASTIC BUSHING