Pando Orpan Manuel De L'utilisateur Et D'installation page 30

PROBLEM
The remote control does
not work....
The hood does not obey the
remote control .....
The Touch Control panel
does not respond, or starts
up by itself.
NOTE ON RESET:
Our hoods are fitted with circuits with a locking protection system which in some cases will prevent
damage due to small variations in the power supply. Unlocking this system involves a simple reset
process as described in the trouble-shooting table.
EN
- 30 -
All manuals and user guides at all-guides.com
SOLUTION
• Check the remote control battery to ensure it is not run down, replace
if necessary, as indicated on page 17.
• Synchronise the remote control with the hood, follow the synchronisation
instructions in the manual. * Disconnect the power, reconnect and
before 15 seconds have passed, keep the control light key pressed
until the lights turn on.
• Contact the official technical service.
• Clean and dry the outside of the control panel with a dry cloth. Due
to condensation or contact the smooth touch surface on the control
panel may have become dirty and therefore not work properly.
• Contact the official technical service.