Pando Orpan Manuel De L'utilisateur Et D'installation page 26

ROUND TWO-PIN BULB
a) Make sure the device is disconnected from the electrical power supply.
b) Give the chrome decorative cover a quarter turn.
c) Take care that the decorative cover together with the protective glass in it do not fall down.
d) Replace the bulb with a similar one (TWO-PIN, max. 20 W, 12 Volt, G4 fitting).
e) Replace the decorative cover and give it a quarter turn in the opposite direction.
ROUND LED LIGHT
(To be carried out by Pando technical support service only).
1. Disconnect the hood from the power supply.
2. Remove the filters.
3. Free the Sec tray by removing the screws holding it in place.
4. Lower the Sec tray carefully as the LEDs are connected internally and pulling it too hard runs the risk
of damaging the wiring.
5. Undo the connector above the LED to be changed.
6. Push the LED downwards according to the diagram, at the same time pressing the side tabs inwards.
7. Locate the new LED and push it into the tray until it fits into place.
8. Join the connector above the LED to the wire in the hood from which it was disconnected in step 4.
9. Lift up the Sec tray and screw it back securely into the body of the hood, taking care not to catch any
of the cables between the sides of the tray and the hood casing.
10. Fit the filters, connect the filter to the power supply and test it.
ELFO or ELFOLED CIRCULAR LAMP
a) Make sure the device is switched off.
b) Pressing gently upwards, turn the Elfo-LED a little to the left and it will fall out.
c) Replace the Elfo-LED and fit it once more, this time by turning it to the right.
EN
- 26 -
All manuals and user guides at all-guides.com