BorMann Pro BGB2035 Manuel D'utilisation page 8

EN
Engine oil check
- Place the engine on a level surface with engine stopped.
- Check the engine oil level.
- Remove the oil maintenance cover.
- Remove the dipstick and wipe it clean.
- Reinstall dipstick into hole; rest on oil fill neck, DO NOT
thread cap into hole.
- Remove the dipstick again and check oil level. Level should
be between the upper and lower limit.
- Fill to the upper limit of the dipstick with the recommended
oil if the oil level is too low.
- Reinstall and fully tighten the dipstick.
Refer to add oil instruction in MAINTENANCE section for
more information.
Oil capacity (rated): See Technical data
Oil is a major factor affecting performance and service
life.
Use 4-stroke automotive detergent oil recommended in
the MAINTENANCE section of this manual.
Operate generating set only on levelled surfaces. The engine is equipped with a low oil sensor
(applicable types) that will automatic stop the engine when the oil level falls below the safe limit.
To avoid the inconvenience of an unexpected shut-down. Fill to the upper limit and check the oil
level regularly.
This engine is not filled with oil before send out from the factory. Any attempt to crank or start the
engine before it has been properly filled with the recommended type and amount of oil may result
in engine damage and void your warranty.
Be sure not to fill above the upper limit mark. Always allow room for fuel expansion.
Fuel capacity (rated): see Technical data
FIRE OR EXPLOSION
Gasoline is highly flammable and extremely explosive.
Keep flammable items away while handling gasoline.
Fill fuel tank outdoors and in a well-ventilated area with the generating set stopped.
Always wipe off spilled fuel and wait until the fuel has dried before starting the generating set.
DO NOT operate the generating set with known leaks in the fuel system.
Regularly check if there is any leak on fuel system.
Use proper fuel storage and handling procedures. DO NOT store fuel or other flammable materials
nearby.
Keep fire extinguisher handy and be prepared if a fire starts.
NEVER use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
It is important to prevent gum deposits from forming in essential fuel system parts, such as the carbu-
retor, fuel filter, fuel hose or tank during storage.
Acidic fuel can damage the fuel system of the generating set while in storage. Be sure to review the
instructions given in "Storage'' section.
Effects of old, stale or contaminated fuel are not warrantable.
8
WWW.BORMANNTOOLS.COM
Dipstick
Upper limit
Lower limit
Generating set fuel check
With the engine stopped, check the fuel level. Re-
fill the fuel tank if necessary.
Use clean, fresh, regular unleaded gasoline.
DO NOT mix oil with gasoline.
Always wipe up any spilled fuel.
Pressure can build up in the fuel tank. Allow
the generating set to cool for at least two min-
utes before removing fuel cap.
Loosen the fuel cap slowly to relieve any pres-
sure in the tank.
Do not fill the fuel tank above the upper lim-
it. Over fill will result in engine die or damage
the carbon canister (if equipped) and void your
warranty.
To minimize gum deposits in your fuel system
and to insure easy starting, do not use gasoline
left over from the previous season.
Allow the generating set to cool for at least
two minutes before removing fuel cap when
adding fuel.
Loosen the fuel cap slowly to relieve any pres-
sure in the tank.