Hot Surface; Moving Parts; Electric Shock - BorMann Pro BGB2035 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

HOT SURFACE

Running engines produce heat. Severe burns can occur on
contact.
DO NOT touch engine while operating or just after stopping.
Avoid contact with hot exhaust gases.
Maintain at least three feet of clearance on all sides to en-
sure adequate cooling.
Combustible material can catch fire on contact.
Maintain at least five feet of clearance from combustible
materials.
Before each use, check for loose or damaged parts, signs
of oil or fuel leaks, and any other condition that may affect
proper operation.
Repair or replace all damaged or defective parts
Immediately.
Locate all operating controls and safety labels.
Make sure all the safety instructions are In right and working
condition. Operate only on level surfaces.
DO NOT expose generating set to excessive moisture, dust,
or dirt.
Keep all safety guards in place and in proper working order
at all times.
DO NOT allow any material to block the cooling slots.
DO NOT allow children or untrained persons to operate the
generating set.
DO NOT run the generating set unattended. Tum off the gen-
erating set before leaving the area.

ELECTRIC SHOCK

This generating set produces powerful voltage and the produced electrical current CAN KILL YOU. This generating set must be properly connected to an
appropriate ground in order to prevent an electric shock. Failure to properly ground the generating set may result in electrocution, especially if the gener-
ating set is equipped with a wheel kit. Consult an electrician for local grounding requirements. Installation should be performed by a certified electrician.
Improper installation can result in electric shock and death. To reduce the risk of electric shock. DO NOT use electrical cords that are worn, frayed, bare or
otherwise damaged. DO NOT touch bare wires or receptacles. DO NOT operate the generating set in wet weather. Keep the generating set dry. DO NOT
handle the generating set or electrical cords while standing in water, while barefoot, or while hands or feet are wet. Keep children or pets away from the
generating set. DO NOT hook up any generating set to a building electrical system without the proper use and installation of a transfer switch installed by
a qualified electrician. When using the generating set for backup power, notify the respective utility company (Distribution System Operator, DSO). Use an
approved transfers switch for the generating set in order to isolate the generating set from the electric utility. Failure to isolate the generating set from the
power utility can result in death or injury to electric utility workers due to back-feed of electrical energy.
3
FIRE OR EXPLOSION
Gasoline is highly flammable and extremely explosive.
Fire or explosion can cause severe burns or death.
Keep flammable items away while handling gasoline.
Fill fuel tank outdoors and in a well-ventilated area with the engine stopped.
Always wipe off spilled fuel and wait until the fuel has dried before starting the
engine.
DO NOT operate the engine with known leaks in the fuel system.
Use proper fuel storage and handling procedures. DO NOT store fuel or other flam-
mable materials nearby.
Empty the fuel tank before storing or transporting this generating set.
Keep fire extinguisher handy and be prepared if a fire starts.

MOVING PARTS

Moving parts can cause severe injury. Keep hands and feet away.
DO NOT operate generating set with covers, shrouds, or guards removed.
DO NOT wear loose-fitting clothing, dangling drawstrings or items that could be
caught. Tie up long hair and remove jewellery.
Moving parts may catch operator's hand, feet, hair or clothes that will cause trau-
matic amputation or broken bones, fracture. NEVER place fingers, hands, or body
near the generating set when it is running.
WWW.BORMANNTOOLS.COM

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

047247

Table des Matières