Ambient Temperature - BorMann Pro BGB2035 Manuel D'utilisation

EN
Generating set maintenance
Use a damp cloth to clean exterior surfaces of the generating set. Use a soft brush to clean the dirt and oil.
Use an air compressor (25 PSI) to clear dirt and debris from the generating set.
Inspect all air vents and cooling slots to ensure that they are clean and unobstructed.
DO NOT use water to clean the generating set. Water can
enter the generating set through the cooling slots and dam-
age the generating set windings.
Engine maintenance
Engine oil
Only use four-stroke engine oil of SJ SL or equivalent level which are in accordance with or
higher than API standard.
Check the API label on oil bottle or other container, and make sure the "SJ, SL" or equiva-
lent level letter is in the label.
SAE 1OW-30 is recommended for general, all-temperature use.
Other viscosities shown in the chart may be used when the average temperature in your
area is within the indicated range.
Oil capacity (rated): see Technical data
Adding oil
a. Place the engine on a level surface.
b. Remove the air filter maintenance cover and dipstick, wipe it clean.
c. Add recommended oil to the upper limit.
d. Fully tighten the dipstick and reinstall the air filter maintenance cover.
e. Properly dispose of any used oil at an approved waste management facility.
14
It is forbidden to tamper with the generator in any of the above ways.
Do not tamper with the inverter speed. The generator is set to the correct rated
frequency and voltage before factory. Tampering with the factory settings of the
inverter without authorization will void your product warranty.
Dipstick
Upper limit
Lower limit
WWW.BORMANNTOOLS.COM

Ambient temperature

Oil level check
Insert the dipstick Into filler
port and stay at the filler neck.
Do not screw the dipstick into
the port, then remove the dip-
stick and check the oil level.