Air Filter - BorMann Pro BGB2035 Manuel D'utilisation

EN
Changing the oil
a. Place the machine on a level surface which is
300mm higher than the ground.
b. Remove the air filter maintenance cover.
c. Remove the oil drain plug.
e. Fully tighten the drain bolt before reinstalling the drain plug.
f. Add recommended oil to the upper limit.
g. Fully tighten the dipstick and install the air filter maintenance cover back in place.
h. Properly dispose of any used oil at an approved waste management facility.
The engine is not filled with oil at the factory. Any operation before it has been
properly filled with the recommended type and amount of oil may result in engine
damage and void your warranty.

Air filter

a. Remove the Air filter maintenance cover.
b. Loosen the filter fix clamp and remove the cover of the air filter.
c. Remove the foam filter element.
d. Wash in liquid detergent and warm water.
e. Squeeze thoroughly dry in a clean cloth.
f. Saturate in clean engine oil.
g. Squeeze in a clean absorbent cloth to remove excess oil.
h. Assemble the filter element onto the filter unit
i. Assemble the filter fix clamp.
j. Reinstall the air filter maintenance cover.
Spark plug
a. Remove the maintenance cover of spark plug.
b. Remove the spark plug cap.
c. Using socket wrench to loose and remove the spark
plug.
d. Inspect the spark plug and spark plug washer, if it
was broken or worn, replace with a
new one. Clean the spark plug with wire brush if reuse
it.
e. Check spark plug gap.
Carefully bend side electrode to adjust the gap if nec-
essary.
15
Change oil when the engine
Is warm from operation.
d. Place the oil container box under the oil drain hole of the generator and remove
the drain bolt to drain out all the used oil.
DO NOT run the engine without
the air filter, or serious danger
can result.
Spark plug gap:
0.6mm-0.8mm
WWW.BORMANNTOOLS.COM