Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Fuel tank cap
Remove the fuel tank cap by rotating it anticlockwise.
Ventilation knob (If applicable)
The fuel cap is equipped with a ventilation knob to prevent fuel leakage. During operation,
the ventilation knob must be in the "ON" position for the generator to operate normally.
When the generator will not be use for a long time or needs to be transported, turn the
ventilation knob to the "OFF" position to prevent fuel leakage.
Telescoping handle
When moving the generator, please hold the telescoping handle and press the button on
it, and pull it outward.
Note: Before moving, please turn off the generator and fuel switch.
Please move the generator on a relatively flat ground. Do not perform the movement on a
surface where the pit exceeds 40mm.
Operating instructions
Operating checklist
Operating Location
Only use OUTSIDE and place the generating set in a well-ventilated area.
Only operate the generating set on a flat, level surface and in a clean, dry operating environment.
Allow two feet clearance on all sides of the generating set while operating it outdoors.
Operate in specified area, if any problem on applicable occasion, please consult the authorized local dealers. In some areas generating set must be registered
with the local utility.
Generating set used to construction sites may be subject to additional rules and regulations.
TOXIC FUMES
The exhaust of the generating set contains carbon
monoxide, using engine indoors CAN KILL YOU !
NEVER use inside any building or any kind of en-
closure, EVEN IF doors and windows are open.
Place the generating set in a well-ventilated and
clean area. Note the wind direction and air cur-
rent when placing the generating set.
Operating Condition
Check for loose or damaged parts, signs of oil or fuel
leaks, and any other condition that may affect proper
operation.
Repair or replace all damaged or defective parts im-
mediately.
Clean the dirt or foreign objects on the surface around exhaust and air intake of generator.
DO NOT move or tip the generating set during operation.
Use generating set only for intended uses. If you have questions about Intended use, ask your local dealer.
7
High altitude
This generating set may require a high altitude carburetor kit to ensure correct operation at high alti-
tudes. Consult the authorized local dealer for high altitude kit information if you always operate your
engine at altitudes above 5,000 feet (1,500 meters).
Even with carburetor modification, generating set horsepower will decrease about 3.5% for each
1,000 feet (300 meters) increase in altitude. The effect of altitude on horsepower will be greater
than if no carburetor modification is made.
Operation the engine at altitude below 5, 000 feet (1,500 meters) with modified carburetor may
cause the generating set to overheat and result in serious engine damage. Please restore factory
specifications of the carburetor at the dealer when using the engine In a low altitude area.
Failing to correct problem(s) before operation could result in property damage, serious injury or
DEATH.
WWW.BORMANNTOOLS.COM
Publicité
Table des Matières
