BorMann Pro BGB2035 Manuel D'utilisation page 11

EN
Connect to electrical devices
1. Inspect power cord for damage before using.
There is a hazard of electrical shock from crushing, cutting or heat damage.
2. Make sure that the generating set has been properly grounded. If the electric devices
require grounding, the generating set must ground.
3. Make sure that the electric devices are in "OFF" position.
4. Allow the engine to stabilize and warm up for a few minutes after starting.
5. Connect and start the electric devices.
6. Turn off all electric devices and disconnect them from the generating set.
7. If the generating set supplies for several loads or electric devices, start the smallest one
first and the largest one last.
ELECTRICAL SHOCK
To reduce the risk of electrical shock, DO NOT use electrical cords that are worn,
frayed, bare or otherwise damaged.
DO NOT touch bare wires or receptacles.
DO NOT handle generating set or electrical cords while standing in water, while bare-
foot, or while hands or feet are wet
Loading capacity
You must make sure your generating set can supply enough rated (running) and (starting)
watts for the electrical devices at the same time.
Follow these simple steps to calculate the running and starting watts necessary for your
purposes.
A. Count the electrical devices you will power at the same time.
B. The amount of power you need to run with the devices is the total rated (running)
watts of these items.
C. Starting power is the power needed shortly when electric devices start. Since not all
devices start at the same time, starting power can be estimated by the maximum power
of all devices plus the total power counted in step b.
Electric equipment
Appliances
Electric tools
11
Wattage Reference Chart
Tablet TV 27''
Energy saving lamp
Electric cooker
Computer
Electric fan
Washing machine
Refrigerator
A/C
Electric hammer
Impact hammer
Water pump
Electric welding machine
Air compressor
WWW.BORMANNTOOLS.COM
If connected devices overheat, turn them off and dis-
connect them from generating set.
DO NOT overload the generating set.
Exceeding the generating sets capacity can damage the
generating set and/or electric devices connected to it.
It Is necessary to equip with circuit protector or switch
to Isolate the generating set from the electric utility
when the generating set is mainly used for backup. Fail-
ure to isolate the generating set from the power utility
may result in injury or death to electric utility workers
and damage to the generating set due to back feed of
electrical energy.
Rated power (W)
80
5-50
1000
250
50
250
50
1600
1000
3000
2200
5000
5000
Starting power (W)
100
5-50
1000
250
100
500
300
3200
1500
6000
5000
7500
10000