Cleaning; Adjusting The Riving Knife - Evolution FURY 5-XS Instructions D'origine

www.evolutionpowertools.com
• Lift the plate away and carefully store it and its fixing screw for
future use.
• Raise the blade to its highest position.
• Use the two blade changing spanners provided. One spanner
will fit the hexagonal nut machined onto the outer blade flange,
and thus prevent the arbor from rotating. The other spanner will
fit the arbor nut. (Fig 36)
• Remove the arbor nut, the outer blade flange and the blade.
• Thoroughly clean any debris from these parts and also from the
exposed motor arbor and inner blade flange. The inner blade
flange can be left in situ.
• Fit the new blade. Ensure that the teeth are facing to the front of
the saw (Fig. 37), and that the rotation arrow on the blade is in
conformism with the rotation arrow on the motor housing.
• Replace the outer flange and nut and tighten securely with the
spanners provided. Check that both blade flanges are in contact
with the blade.
• Replace the table access plate and its fixing screw.
Ensure that the fixing screw is correctly seated.
• Replace the top blade guard.

CLEANING

After each use the machine should be cleaned. Remove all sawdust,
etc. from the visible parts of the machine with a workshop vacuum
cleaner. A workshop dust extraction can also be connected to the
machine dust extraction port at the rear of the machine. This should
remove debris from the inside of the machine. Never use solvents to
clean plastic parts, as solvents can damage them. Clean only with a
soft damp cloth.
RIVING KNIFE
The riving knife is a very important component and comes factory
fitted and correctly aligned and adjusted. The riving knife prevents
the work from chattering and/or binding as it passes through the
blade. Inspect the riving knife at regular intervals and if it is worn or
damaged have it replaced with an original replacement part, fitted
by a competent technician.
Note: Use only a genuine Evolution riving knife, as this is a
dedicated component for this machine. Non genuine parts could be
dangerous. If in any doubt, please contact the helpline.

ADJUSTING THE RIVING KNIFE

The riving knife should be adjusted so that the teeth of the blade are
within 3-5mm of the edge of the riving knife (Fig. 38).
To adjust the riving knife, remove the table insert as shown on
page 22, raise the blade to its maximum height and loosen the bolt
securing the riving knife (Fig. 39) with the spanner supplied. Adjust
the riving knife to the correct distance of 3-5mm, ensuring the fixing
Fig. 37
Fig. 38
Fig. 39
23
3-5mm
EN
FR