Dual Read Scale; Mitre Gauge - Evolution FURY 5-XS Instructions D'origine

www.evolutionpowertools.com
Return to the original configuration when the rip fence is in the
normal (RH) operating position.
THE DUAL READ SCALE
Note: The rip fence guide incorporates a viewing window to aid
reading the measurement scale found on the fence rail.
(Fig. 22). The scale should be regarded as a useful guide. It is not a
substitute for careful and accurate 'marking out'.
This machine has a dual read scale that shows the distance from
the blade to the rip fence through the viewing window. This can
be used to aid setting the cutting distance from the blade to the
rip fence. With the rip fence faceplate attached by its shorter side,
use the black scale to set the distance of the rip fence. When the
faceplate is attached by its longer side, use the green scale.

MITRE GAUGE

Note: The mitre gauge (D) (Fig. 23) can be used on either side of
the table and runs in either of the two inverted 'T' slots in the table
top.
Carefully slide the mitre gauge into the required slot in the table top.
Turn the vertical handle counter-clockwise to unlock the mitre
gauge, and adjust to the required angle. Turn the handle clockwise
to lock the mitre gauge at the chosen angle. (Fig. 24)
Fig. 21
Fig. 22
Fig. 23
Fig. 24
19
EN
FR