Tilting The Blade; Rip Fence Guide - Evolution FURY 5-XS Instructions D'origine

Fig. 17
Fig. 18
Fig. 19
Fig. 20
Note: When the machine is not in use we recommend that the
blade is fully lowered into the machine and that the top guard
is lying flush on the saw table. (Fig. 17)

TILTING THE BLADE

The blade can be tilted by up to 45˚ to the left hand side.
To tilt the blade:
• Loosen the tilt locking knob (Fig. 18)
• Push in the dual function hand-wheel and ensure that the
cog engages with the track.
• Turn the hand-wheel to tilt the blade.
Note: A protractor scale and pointer (Fig. 19) are readily visible
allowing the operator to quickly set the blade to the desired angle.
• When the desired angle has been achieved the tilt locking knob
should be tightened to secure the blade angle.
Note: We recommend that when any tilt cutting operation is
concluded that the blade be returned to its normal (vertical) setting
and the tilt locking knob tightened.

RIP FENCE GUIDE

The rip fence (C) can be positioned either side of the blade and is
locked in position by using the locking handle.
• Push down to lock, and pull up to unlock. Do not use undue force
on the locking handle. Gently push down on the handle with the
palm of your hand until the handle 'clicks' into place.
Forwards and backwards adjustment of the rip fence faceplate
(Fig. 20) is possible. Loosen the two wing nuts and slide the
aluminium faceplate to the desired position. Tighten the wing
nuts securely.
Note: We recommend that normally the rip fence faceplate be
adjusted so that the rear of the faceplate guide is 'in line' with the
rear of the blade where it emerges from the table. (Fig. 21)
Note: If the rip fence is used on the LH (left hand) side of the blade,
the aluminium faceplate will have to be repositioned
to the RH (right hand) side of the plastic carrier.
• Loosen the two wing nuts and slide the aluminium faceplate
from the plastic carrier.
• Remove the dome headed machine screws from the carrier.
• Reposition the faceplate to the RH side of the carrier and
re-attach using the machine screws and the wing nuts. Adjust
as necessary.
18
www.evolutionpowertools.com