Compound Mitre Cutting; Repetitive Cross-Cutting; Rip Cutting - Evolution FURY 5-XS Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.evolutionpowertools.com

COMPOUND MITRE CUTTING

Note: Compound mitre cutting is achieved when the machines
blade is tilted from the vertical and the mitre gauge is set to an
angle. A compound cut is therefore a combination of a mitre cut
and a bevel cut. (Fig. 29)
• Adjust the mitre gauge and set to the desired angle.
• Tilt the blade to the desired angle and lock in place by tightening
the tilt locking knob.
• Check that the mitre gauge will pass the saw blade without any
interference. Adjust the mitre gauge faceplate if necessary.
• Index and securely hold the material against the mitre gauge
faceplate and make the cut.

REPETITIVE CROSS-CUTTING

Repetitive cross-cutting is the process of cutting a number of
pieces to the same length without having to mark out each piece
separately.
Note: We recommend that repetitive cross-cutting is carried out
with the mitre gauge positioned on the LH side of the machine, with
the rip fence on the RH side of the machine. (Fig. 30)
WARNING: The rip fence can be used as a length stop only as long
as it is properly set and adjusted.
To set the rip fence for repetitive cross-cutting:
• Set the rip fence at the required distance from the saw blade.
• Adjust and align the back of the rip fence faceplate with the front
of the saw blade. (Fig. 31) This setting will afford clearance for
the material as it passes through the saw blade. It will allow the
cut material to move sideways away from the saw blade, with
little risk of any binding or kickback occurring.
Index and hold the material to be cut against the mitre gauge
faceplate and the also index the material gently against the rip
fence. Hold the material and mitre gauge securely with your left
hand. Gently push the workpiece through the saw. Use a push stick,
if necessary, in your right hand to guide the workpiece on the RH
side of the blade.

RIP CUTTING

Rip cutting is the process of cutting along the length of a piece of
material rather than across it.
Rip cutting should be done with the rip fence set at the desired
width from the saw blade and normally on the RH side of the
machines table. (Fig. 32)
The mitre gauge is not required for this operation, and should be
stored safely off the machine for future use.
Fig. 29
Fig. 30
Fig. 31
Fig. 32
21
EN
FR

Publicité

Chapitres

Table des Matières
loading

Table des Matières