Top Blade Guard - Evolution FURY 5-XS Instructions D'origine

Fig. 9
Fig. 10
Fig. 11
Fig. 12
The pillar of the anti-bounce device fits into the socket in the
mitre gauge base, and is held in place by a thumb screw. (Fig 9)

TOP BLADE GUARD

The top blade guard (A) (Fig. 10) (sometimes referred to as
a crown guard) must always be fitted to the machines riving
knife. The 'split' line along the top of the guard indicates the
centre line of the saw blade below.
WARNING: The top blade guard must be fitted to the
machines riving knife.
WARNING: The machine must be disconnected from the
mains supply when installing the blade guard.
• Raise the blade to its full height to fully reveal the riving
knife. (Fig. 11)
• The guards locating pin should be positioned through the
hole machined in the top edge of the riving knife (Fig. 12).
A wing nut is fitted to one side of the top guard.
Note: Adjust the blade guard for the material you are cutting.
To adjust to the thickness of the material being cut, the blade
guard must pivot up and down easily and smoothly, so do not
over-tighten this wing nut.
• Check the operation of the blade guard. Ensure that it is
working efficiently and covers the blade at the sides as well
as the crown.
• Lower the blade a little and recheck that the blade guard
operation.
• When satisfied that the blade guard works throughout
the blades height adjustment range, check that the guard
works equally well with the blade set to a bevel angle.
• Check that when the blade is fully lowered, the blade guard
is in contact with the table top.
Note: The top blade guard is equipped with a dust extraction
port (Fig.13).
• Connect the supplied dust extraction hose to the top blade
guard. The hose is a 'push fit' onto the extraction port.
• Connect the other end of the hose to the 2 way connector
found to the rear of the machines main body. (Fig. 14)
16
www.evolutionpowertools.com