Connection And Start-Up - Migatronic OMEGA2 Guide De L'utilisateur

Connection and start-up

Warning
Read warning notice
and instruction manual
carefully prior to initial
operation and save the
information for later use.
Unpacking the OMEGA C
2
After unpacking and prior to use, proceed as
follows (see drawing):
Permissible installation
Mains connection
Connect the machine to the correct mains supply.
Please read the type plate (U
the machine.
yellow/green
brown
black
grey
yellow/green
brown
black
grey
Important!
In order to avoid destruction
of plugs and cables, good
electric contact is required
when connecting earth cables
and welding hoses to the
machine.
Connection of welding hose
Fastening the torch holder
Lifting instructions
) on the rear side of
1
Lifting hooks can be used at the OMEGA
the OMEGA
(figures 1 and 3).
3x200-440V
The OMEGA
lifted with a crane but only manually using the
L1
handle (figure 2).
L2
L3 The machine must not be lifted with a mounted
N
gas cylinder!
1x200-440V
L
N
Fig. 1
sack barrow for lifting with a crane
2
2 trolley with four wheels cannot be
Fig. 2 Fig. 3
S and
2
11